FPV Drone 18 Inch

• The FPV has flexible and stable flight performance
• The maximum take-off altitude is about 5000 meters
• Using high-efficiency 6218 motor
• The maximum speed is 100 KM/H
• The maximum flight distance is 30km
• Rated load: 13000g
• Combat load:13 000 -  20 000g
• Maximum take-off weight: >  27 000g
• No-load endurance time: 38 min ( 12S 44,4V22000MaH )
• Rated load endurance time: 18min 20s ( 12S 44,4V 25000 MaH )       
  
• Net Weight: 2093g
• Size Inch (mm): 600*500*60
• Frame: 18Inch Frame
• Wheelbase: 596mm
• Flight Control: BL F405 (Optional)
• ESC: KLESM 120A 4-in-1
• VTX: KLESM 5.8G 3W Video Transmission
• Camera: KLESM1500TVL FPV Camera
• Motor: KLESM 6218 200KV
• Propeller: 18*6*4(carbon fiber nylon)
• Recommended battery: 12S 25000 10-45C XT90 plug

1. Program M-H-30 
   MCU  EFM8BB21F16G-C-QFN20R 
   Continuous current 120AX4 
   Instantaneous current 120A-12S 
   TVS protection diode Yes 
   Electrolytic capacitor 2000uF Low ESR Capacitor 
   Motor protocol Dshot300/600 
   Battery input 3-12S Lipo 
   Amperemeter Support 
   Power output VBAT 
   Mounting hole 30.5x30.5mm 
   Dimensions 43x37x7mm 
   Weight Bare board 12g 
2. Main control chip STM32F405RGT6 
   Gyroscope ICM42688 
   USB Type-C 
   Barometer BMP280 
   OSD chip AT7456E 
   Bluetooth Not Support 
   RSSI Supported, marked as RSSI 
   Support flight control firmware Beataflight/INAV 
   Mounting hole position 30.5x30.5mm/M4 
   Dimensions L36mmxW36mmxH8mm 
   Weight Bare board 10g 
3. Motor: 6218 200KV
   Weight (Incl.cable): 313.5g
   Internal Resistance: 0.090Ω
   Motor Wire: Silicone 18AWG-133mm
   Configuration: 12N/14P
   Shaft Diameter: 5.0mm
   Rated Voltage: 3-6S
   Idle Current: 1.48A/10V
   
4. Input voltage 7V to 36V, suggest at least 6S battery
   Output power PIT/25/1000/2000 mW/MAX (MAX>3000mW)
   Channel No.: 80CH (A-B-E-F-R-L-O-U-H-X)
   Microphone Not supported
   Antenna connector MMCX
   VTX Protocal: IRC
   Cable connector JST, 6pin
   Dimensions 53X29.4X14.4mm, 20x20mm/M2 (hole)
   Weight 20g (excluding antenna)
5. Frequency range (MHz) 4900-5800
   Polarization Omnidirectional
   Gain (dBi) 3
   Input impedance (Ω) 50
   VSWR (5800MHZ) ≤1.5
   Maximum input power (W) 50
   Connector type SMA
   Dimensions-mm (Height/Width/Depth) 34*150±2
   Antenna weight (SMA) SMA 13g
6. Model KLES19 FPV cameras
   Lmage Sensor SONY 1/2.8＇
   Horizotal Resoulution 1500TVL Lens 2.1mm
   Min lllumination 0.001Lux
   Power DC 5V-30V
   Net weight 6.0g
   Dimensions 19mm*19mm*22mm
   Working Temperature -20°-70°
7. MCU: ESP8285
   Input: 5V
   Operation Current: ~100mA
   Rx To FC protocol: CRSF
   RF Frequency: 915MHz(FCC) / 868MHz(LBT)
   Dimension: 16*12*3mm
   Weight: 0.60g
   Antenna Connector: IPEX1
8. GemFan 18*6*4Inch Prop (2 pairs)

Recommended battery: 12S 25000mah 25C XT90 plug